2024 Hyundai ELANTRA: Compact Car (2024)

Forward Collision-Avoidance Assist with Pedestrian Detection and Cyclist and available Junction-Turning Detection

This standard safety innovation detects rapid closing distances to the vehicle ahead, pedestrians in your path and, when equipped, cyclists. If a potential forward collision is detected, audible and visual warning notifications will alert the driver. If the driver does not react to avoid impact, the system can apply emergency braking under certain conditions.
This advanced technology also includes standard cyclist component. The available junction-turning component is there to help make left turns at an intersection safer.

Adaptive Cruise Control with traffic stop and go

The available Adaptive Cruise Control (ACC) system takes basic cruise control to the next level of convenience. Set your pre-determined speed and distance to the vehicle ahead, and ACC will automatically adjust your speed to maintain the set distance. The system will even operate in stop-and-go traffic, bringing the vehicle to a complete stop when necessary and then resuming automatically.

High Beam Assist

Using the front-mounted camera and light detection technology, standard High Beam Assist provides an extra level of convenience by automatically switching between high and low beams when traffic is detected ahead.

Blind-Spot Collision-Avoidance Assist

Available Blind-Spot Collision-Avoidance-Assist not only uses radar to detect when a vehicle is in the driver’s blind spot, but will also help avoid a collision by gently applying brake power on the opposite tire to help deter an unsafe lane change.

Driver Attention Warning

Designed to detect the onset of driver fatigue, this standard system will monitor driver input and issue a visual and audible alert if fatigue is sensed, suggesting a driving break.

Highway Driving Assist

Available Highway Driving Assist, working in conjunction with Lane Following Assist and Adaptive Cruise Control with traffic stop and go, conveniently helps you keep to the speed limit by adjusting your set cruise control speed as the speed limit changes, based on GPS and highway data, and automatically decreases your speed before entering a highway curve section.

Lane Departure Warning with Lane Keeping Assist

Start drifting outside of your lane without signalling and this standard system is designed to inform you with audible and visual cues. If no action is taken, Lane Keeping Assist can apply corrective steering assistance to help keep the vehicle within the lane markings.

Lane Following Assist

Using the front-view camera to detect lane markers on the road, this standard feature assists the driver’s steering to help keep the vehicle centred inside the lane.

Rear Occupant Alert

As the engine is turned off, a visual warning in the instrument cluster and audible alert reminds you to check the rear seats before exiting.

Safe Exit Warning

When a vehicle approaching from behind in the adjacent lane is detected, this feature warns passengers in advance to keep them from stepping out onto the road when it is dangerous.

Forward Collision-Avoidance Assist (FCA) is designed to detect vehicles, pedestrians or cyclists (depending on the specific FCA type with which the vehicle is equipped) that are directly in front of the vehicle. FCA will not detect all vehicles, pedestrians, cyclists or other objects (as applicable). FCA will not work on winding or hilly roads, during certain weather conditions such as rain, snow, fog and any other times of limited visibility. The speed at which FCA initiates full braking depends on the type of FCA system equipped on the ELANTRA. FCA initiates full braking at speeds between 10 and 60 km/h (vehicle detection) or 10 and 60 km/h (pedestrian detection) if the ELANTRA is equipped with the FCA “camera-type” system. FCA initiates full braking at speeds between 10 and 75 km/h and 10 and 85 km/h (vehicle detection, depending on whether vehicle ahead is in motion) or 10 and 65 km/h (pedestrian and cyclist detection) if the ELANTRA is equipped with the FCA “camera and radar-type” system. FCA will not detect all vehicles, pedestrians and cyclists under certain conditions. Junction-Turning Detection (JTD) provides audible warnings if the system recognizes potential risk of collision with an oncoming vehicle and will automatically apply brakes depending on the collision level. JTD will operate when the driver turns left, if your vehicle’s turn signal is on and vehicle speed is between 10 and 30 km/h, and oncoming vehicle’s speed is between 30 and 70 km/h. See Owner’s Manual for detailed descriptions of example conditions in which FCA may not detect a vehicle, pedestrian or cyclist, or JTD will not detect oncoming vehicle. FCA and JTD are not substitutes for safe driving. Always check your surroundings when driving. See Owner’s Manual for further details and limitations.

Adaptive Cruise Control (ACC) with traffic stop and go is not a collision avoidance or warning device. ACC is for highway use only and should not be used in poor weather, heavy or varying traffic, or on winding or slippery roads. Driver remains responsible to slow or stop the vehicle to avoid a collision. Acceleration after the vehicle comes to a complete stop will only occur when the vehicle has been stopped for less than three seconds. See Owner’s Manual for further details and limitations.

U.S. model shown. May not be exactly as shown.

Never rely completely on Blind-Spot Collision-Avoidance Assist (BCA) and be sure to use proper lane changing procedures. BCA is activated when the vehicle is travelling at least 60 km/h and when the turn signals are activated. BCA will not detect every object or vehicle and will not prevent accidents. The braking function may not always avoid a collision. There are limitations to the function, range, detection and clarity of the system. BCA is dependent on the side, distance, angle and relative speed difference between the vehicle and other vehicles and will not operate if sensors are obscured. Always look over your shoulder and use your mirrors to confirm clearance. See Owner’s Manual for further details and limitations.

Driver Attention Warning (DAW) is only a notification system and will not influence the direction or speed of the vehicle. DAW will not prevent accidents. DAW does not replace attentive and safe driving. Always ensure that you pay careful attention while driving. See Owner’s Manual for further details and limitations.

Highway Driving Assist (HDA), when used in conjunction with Lane Following Assist and Adaptive Cruise Control with traffic stop and go, is for highway use only and can help keep the vehicle centred in its lane while maintaining a safe distance from the vehicle ahead only when the lane markings are clearly visible on the road. HDA will reduce cruise control set speed as the vehicle approaches a curve in the highway. HDA should not be used in poor weather, heavy or varying traffic or on winding or slippery roads. HDA will not work under all circ*mstances and on all highways and will not prevent loss of control. Driver remains responsible to slow or stop the vehicle to avoid a collision. For HDA to maintain the posted speed limit of a highway, the system must be set to the exact speed limit. Only select provincial and territorial highways will apply to this feature of the system. Driver remains at all times responsible for determining the correct speed limit and to abide by such speed limits, including in situations in which a speed limit may be altered, but such change in speed limit is not recognized by the navigation system, such as in the cases of reduced speeds in construction zones or where posted speed limits have been recently increased or decreased. Driver remains responsible for controlling the vehicle to avoid a collision or other accidents. Driver is responsible for maintaining the data of the navigation system up to date. HDA will only fully function when the navigation map data is available for the section of highway that is being driven on. See Owner’s Manual for further details and limitations.

Lane Departure Warning with Lane Keeping Assist operates when vehicle speed exceeds 60 km/h and only when the lane markings are clearly visible on the road and detected by the system. It will not prevent loss of control. See Owner’s Manual for further details and limitations.

Lane Following Assist (LFA) can help keep the vehicle centred in its lane only when the lane markings are clearly visible on the road. Lane Following Assist will not work under all circ*mstances and will not prevent loss of control. Lane Following Assist is a supplemental assist, and does not replace the need for extreme care and attention by the driver. See Owner’s Manual for further details and limitations. Ultimate model with Tech package shown. May not be exactly as shown.

When the vehicle is parked and the engine has been turned off, the Rear Occupant Alert (ROA) can help to alert the driver if the rear door(s) have been opened at any point after the vehicle was unlocked at the beginning of the journey. Upon turning the engine off, ROA will provide an audible alert and a visual alert on the instrument cluster. ROA is not a substitute for driver attentiveness. Always make sure you check rear seats before exiting the vehicle. Do not solely rely on ROA to determine if rear seats are empty. Never leave a child unattended in a vehicle. See Owner's Manual for further details and limitations.

When the vehicle is parked, Safe Exit Warning (SEW) can alert occupants planning to exit the vehicle when a vehicle is approaching from behind. SEW does not prevent occupants from exiting. SEW may not detect every vehicle and may not avoid an accident. SEW is not a substitute for attentive operation of the vehicle. Always monitor the vehicle’s surroundings before any passengers exit the vehicle. SEW operates for approximately 10 minutes after ignition is turned off, unless doors are locked, at which time it turns off.See Owner’s Manual for important details and limitations.